Adafruit FT232H Breakout - General Purpose USB to GPIO+SPI+I2C

Product Information

After rebooting, plug in the FT232H breakot to your PC using a USB micro cable. You should see a message pop up that the device is recognized and a driver is being installed. Upgrading a passive DB9 RS232 Interface to an active USB Interface using an FTDI DB9-USB-RS232 Module

Board: Configuration files for common development boards like “atmel_sam4s_xplained_pro.cfg” - “olimex_stm32_h107.cfg” - “stm32f4discovery.cfg” .. etc. You can see that these files reuse configuration files from interface and target.Supports a half duplex FT1248 interface with a configurable width, bi-directional data bus (1, 2, 4 or 8 bits wide).

FT232R, FT245R, FT232H, FT2232H, FT4232H, FT2232D, FT200XD, FT201X, FT220X, FT221X, FT230X, FT234XD, FT231X, FT240X, FT120, FT121, FT122, FT313H, FT4222H & FT260 Bitbang mode: toggling an I/O pin ‘bitbashing’ which FTDI call ‘bitbanging’, refers to driving the I/O pins directly, rather than using an I/O protocol embedded in the device." BTW: When I am asked to specify the USB device as in the printout above, what should I try? I have already tried the serial number FTLD454D, the productID 0x6014, and the vendorID 0x403. This error could be caused by using libusb driver in windows while new versions of OpenOCD use WinUSB driver.Once the installation is done you might need to reboot your machine if the installation program tells you to do so. openocd -f config1.cfg -f config2.cfg -f config3.cfg Understanding the Basics of Adapter Configuration FT2232H is dual high-speed USB to multipurpose UART/FIFO IC. This means it is a single-chip USB with dual ports. First, make a special configuration file to our adapter. Create a new txt file (ANYNAME.cfg). Remember to edit the VID/PID and serial to match your chip: #This configuration file is created for a tutorial: To use the FT_PROG programming tool from FTDI you might need to erase the EEPROM of the FT232H to put it into a state where FT_PROG can detect the device. To do this you can use a small eeprom command line tool from libftdi by following the steps below. Note that these steps are for Windows users (since FT PROG is only usable on Windows).